Hammer Drive Anchor 1/4" Diameter (10, 1-1/4 inch Long)

Applications The anchor is made from ZAMAC. This anchor is designed for use in Concrete, Block, and Brick. Environment The anchor is designed for use in a Dry environment. Hole Diameter/Bit Diameter The anchor requires a 1/4" hole to be drilled in the base material (Concrete, Block, and Brick). The hole should be drilled with carbide tipped bit that meets ANSI standards and used in a hammer drill. Diameter of Anchor The diameter of the anchor is 1/4". Minimum Embedment The minimum anchor embedment into the concrete is 3/4". Therefore, the anchor must be installed so that a minimum of 3/4" of the anchor is embedded into the concrete. Spacing between Anchors Each anchor must be spaced a minimum distance of 2-1/2" from each other when measured center to center. Edge Distance It is very important not to install the anchor any closer than 1-1/4" from an unsupported edge of the concrete.

• Material Zamac
• Designed to act as a permanent anchor in applications that do not require quick disassembly
• Recommended for light duty fastening in concrete, block, brick, and stone
• Common applications include masonry anchorage, drywall track, electrical fixtures, gutters, and brackets
• Anchor could pull out of material and fall when attempting to support an overhead load
• Has a 1/2" fixed mushroom washer head